Kenny, thanks for your help.. Would you or anyone else mind drawing up the part to see if you get different results? This part is a 7" diameter 30* elbow. I don't recall having these issues with previous versions of SE, and since i don't do these often, i tend to forget which method i normally ...

Kenny, thanks for the reply. The video was on 2023 When i start in SM, i create all the sketches and sweeps for the whole part having 4 - 8 sections. After surface sweep, i add a SM body, transition to part, thicken, then flatten. I do this for each wedge (gores). Here is the results done the same w...

Im working on lobster tail piping and noticed the flattened length is shorter than it should by by almost an inch. I upgraded to SE2024 from SE2023, these issues did not happen in 2023. I failed to save my settings before upgrading so 2024 is fully OEM settings. Are there bend settings in SE other t...

I've been "learning" SE community edition for a couple years, I draw parts one at a time, but recently started trying to design parts in place. This basket was drawn in 4 pieces then assembled. I'm showing the pathfinder to get some recommendations from you guys. I watched this video along...

Sorry this is my first post UU I was hoping to see SE represented. Watching the tournament has my eyes bouncing left to right watching the different techniques because I'm a total CAD noob but have been learning SE via YT. Watching them I kept saying 'That can be done in SE by ____ ...' based on vid...