How to change size of virtual sharps

[Dwight]

All

Any way to increase the size of a virtual sharp? I see no controls in the settings.

Thanks

Dwight

[Glenn Schroeder]

Howdy Dwight,

You can choose between several types of virtual sharp marks, as I'm sure you know, but I'm pretty sure you can't change their size.

[Dwight]

Thanks, Glen. I thought just maybe it was tied to some other setting, though I've not seen a hint of that. I will continue to sketch them when I need something bigger.

[Glenn Schroeder]

. . . I will continue to sketch them when I need something bigger.

I assume the "Witness" option isn't suitable? Or maybe you just don't want them all that style?

[Dwight]

I do use the witness option. It usually provides a couple microscopic lines, as shown in the image.

[Dwight]

I add a sketch to get something like this:

[SamSpade]

There is a way of making them longer by increasing the extension lines (beyond the dimension) setting, but that would affect all other dimensions attached to that style.

[Dwight]

There is a way of making them longer by increasing the extension lines (beyond the dimension) setting, but that would affect all other dimensions attached to that style.

Thanks, SamSpade. That's interesting, so I am glad you answered, but what a bad choice of linked controls by Solidworks.

Dwight

[Dwight]

I voted for SPR# 655170 and commented:

I want to show long extension lines for virtual sharps, long enough to see easily, but at the same time not have other extension lines in a drawing extend a ridiculous amount past their dimension lines. In SW2022, the same setting is used for both, so you can't have one without the other. This does not work. Virtual sharp extension lines should have their own default length setting and should also have property controls that allow you to change the length of an individual extension line (or a pair of extension lines at the very least).