Ok So I know layer mapping for DXF is borked most of the time, But I had it nailed down and its been working flawlessly for months.
Yesterday it just stopped working.
in a DRW, on a blank sheet I have my part view with a sketch that has its file name.
I would export to DXF and layer map "sketch lines" to the "etch" layer.
Everything is now on the zero layer with geometry....
Any suggestions?
Layer Mapping-Yeah I know 8(
- picturedrawerGSS
- Posts: 8
- Joined: Wed Apr 05, 2023 1:56 pm
- x 6
- x 6
- picturedrawerGSS
- Posts: 8
- Joined: Wed Apr 05, 2023 1:56 pm
- x 6
- x 6
Re: Layer Mapping-Yeah I know 8(
uhh well I guess I fixed it. lower left hand corner is an option "only map entities....."
Must have sneezed and checked that box or something
Must have sneezed and checked that box or something
- AlexLachance
- Posts: 2226
- Joined: Thu Mar 11, 2021 8:14 am
- Location: Quebec
- x 2419
- x 2061
Re: Layer Mapping-Yeah I know 8(
Maybe you aren't pointing to your mapfile anymore..?
- picturedrawerGSS
- Posts: 8
- Joined: Wed Apr 05, 2023 1:56 pm
- x 6
- x 6
Re: Layer Mapping-Yeah I know 8(
Not sure, probably just the unusual jankyness going on.
it stop working
I checked that box, no effect.
Today I unchecked the box and it started working.
-Shrugs-
it stop working
I checked that box, no effect.
Today I unchecked the box and it started working.
-Shrugs-