Knowledge Gap - 2D Spiral in Solidworks

jmongi
Posts: 101
Joined: Wed Mar 24, 2021 1:25 pm
Answers: 0
x 15
x 81

Knowledge Gap - 2D Spiral in Solidworks

Unread post by jmongi »

I have probably stumbled into a gap in my knowledge of Solidworks. I know how to define a helix and its limitations. I also did some googling and saw how to generate my own 3D helical sweep path from the intersection of two surfaces.

But, what I need today is a 2D spiral. I'm experimenting on ways to improve the display of texture based wire mesh (using a SW texture, not modelling it). I have a 6" OD x 4" thk mass of wire mesh and I can model the whole outer surfaces and get a decent transparent texture out of it. But, I'm seeing if I can improve the representation. That's just some background.

Anyway, I would like to have a 2D swept spiral with a rectangular cross section. I'm failing to wrap my mind around how to go about doing that. Any pointers would be appreciated.
by Alin » Thu Feb 17, 2022 10:08 am
Same tool as the Helix to create the sweep path. Just use the Spiral option.
image.png
Go to full post
Designated Pot-Stirrer
Alin
Posts: 313
Joined: Sun Mar 14, 2021 9:46 am
Answers: 3
x 265
x 391

Re: Knowledge Gap - 2D Spiral in Solidworks

Unread post by Alin »

Same tool as the Helix to create the sweep path. Just use the Spiral option.
image.png
jmongi
Posts: 101
Joined: Wed Mar 24, 2021 1:25 pm
Answers: 0
x 15
x 81

Re: Knowledge Gap - 2D Spiral in Solidworks

Unread post by jmongi »

Thanks Alin, I was hoping it was something simple I was missing.
I had it in my head that the helix swept a solid because I had been working with helix surfacing tool. Just a brain gaffe.
Designated Pot-Stirrer
Post Reply