Charting positions of post vs holes like a hole chart?

[JMOS4]

Hi all,

Is there a way of charting posts on a chart similar to a hole chart?

I have a plate with about 600 post and want to simplify it as doing it with ordinate dimensions is about useless as you can't decipher what leader/line goes where, and I don't want to have to type them all out either.

Regards,
Jim

[jcapriotti]

If you select the face, it will pick up the posts. It basically finds the edges.

[JMOS4]

Hi again,

Got it to somewhat work, thanks wasn't sure Solidworks would do this.

Regards,
Jim