When ballooning the drawing, Solidworks is edges and surfaces of parts that are suppressed and won't allow me to select the correct component.
Has anyone else seen this?
Assembly drawing ghost objects
Assembly drawing ghost objects
I have an assembly drawing with several configurations.
When ballooning the drawing, Solidworks is edges and surfaces of parts that are suppressed and won't allow me to select the correct component.
Has anyone else seen this?
When ballooning the drawing, Solidworks is edges and surfaces of parts that are suppressed and won't allow me to select the correct component.
Has anyone else seen this?
-
jcapriotti
- Posts: 1852
- Joined: Wed Mar 10, 2021 6:39 pm
- Location: The south
- x 1196
- x 1984
Re: Assembly drawing ghost objects
Maybe an interference? That will cause edges to not show properly as its trying to figure out what is hidden.
Jason
-
Glenn Schroeder
- Posts: 1518
- Joined: Mon Mar 08, 2021 11:43 am
- Location: southeast Texas
- x 1754
- x 2126
Re: Assembly drawing ghost objects
Is this an exploded view? If yes, that's a known bug. See https://www.cadforum.net/viewtopic.php?t=409.
"On the days when I keep my gratitude higher than my expectations, well, I have really good days."
Ray Wylie Hubbard in his song "Mother Blues"
Ray Wylie Hubbard in his song "Mother Blues"