Suppressed components used in symetry
Posted: Fri Dec 01, 2023 8:37 am
We were on 2019 previously, and when we suppressed a component that was used in a symetry, the symetry would give us a pop-up that you could not do a symetry of a suppressed component and then remove the suppressed component.
This is not the case now on 2023, so we have to look in the symetry feature to find the right suppressed component and then remove it. Is this a new setting in 2023? I haven't found anything relating to it, so I was hoping to be able to get back to the previous workflow.
2023 SP5.
This is not the case now on 2023, so we have to look in the symetry feature to find the right suppressed component and then remove it. Is this a new setting in 2023? I haven't found anything relating to it, so I was hoping to be able to get back to the previous workflow.
2023 SP5.