Simulate the suction process with Solidworks Flow Simulation
Posted: Thu Jun 27, 2024 12:16 pm
Hello everyone
I have an analysis problem with solidworks flow simulation to simulate the suction process when creating a vacuum chamber.
You can view the attached file
I set the boundary condition as outlet volume flow: 0.42m3/s and total pressure as 0.3 Torr.
After analysis, I got the results as shown. Can anyone give me advice on this analysis problem?
Thank you!
I have an analysis problem with solidworks flow simulation to simulate the suction process when creating a vacuum chamber.
You can view the attached file
I set the boundary condition as outlet volume flow: 0.42m3/s and total pressure as 0.3 Torr.
After analysis, I got the results as shown. Can anyone give me advice on this analysis problem?
Thank you!