Page 1 of 1
Attach balloon to part in assembly exploded view?
Posted: Wed Dec 18, 2024 9:13 am
by mgibeault
I would like to attach balloon to each part in an exploded view while the balloons show the item number of a "indented-detailed numbering" BOM.
Right now I only can get them to show the sub-assembly number.
Re: Attach balloon to part in assembly exploded view?
Posted: Wed Dec 18, 2024 9:49 am
by AlexB
If you right-click your view and select properties, can you verify that the "Linked to BOM" box is checked?
Edit: Is the BOM they are linked to also set to show indented detail numbering?
Re: Attach balloon to part in assembly exploded view?
Posted: Thu Dec 19, 2024 2:34 pm
by mgibeault
AlexB wrote: ↑Wed Dec 18, 2024 9:49 am
If you right-click your view and select properties, can you verify that the "Linked to BOM" box is checked?
Edit: Is the BOM they are linked to also set to show indented detail numbering?
That's it!
It was linked to a BOM that is on another page!