Page 1 of 1
mate primitives
Posted: Mon Jul 19, 2021 2:50 am
by Assis As
hi
i am trying to understand mate primitives to create two revoulte joint , but could not manage to create joints . i am getting only cylindrical joint
any advice please thank you
Re: mate primitives
Posted: Mon Jul 19, 2021 7:56 am
by zwei
Assis As wrote: ↑Mon Jul 19, 2021 2:50 am
hi
i am trying to understand mate primitives to create two revoulte joint , but could not manage to create joints . i am getting only cylindrical joint
any advice please thank you
I had gotten rather rusty with motion analysis... but have you tried replacing the mates with hinge mate instead?
Edit: added image, reply too fast before image can upload
Re: mate primitives
Posted: Mon Jul 19, 2021 8:09 am
by Assis As
thank you for reply
motion analysis is very complicated specially dealing with redundancies , i did two hinge mates but again i am getting one hinge mate redundancies
Re: mate primitives
Posted: Mon Jul 19, 2021 8:30 am
by zwei
Assis As wrote: ↑Mon Jul 19, 2021 8:09 am
thank you for reply
motion analysis is very complicated specially dealing with redundancies , i did two hinge mates but again i am getting one hinge mate redundancies
Mind sharing your files?
Mine seem ok
Re: mate primitives
Posted: Mon Jul 19, 2021 8:50 am
by Assis As
i had followed your strategy somehow 4 revolute joint , created with two redundancies.please see file
Re: mate primitives
Posted: Mon Jul 19, 2021 9:18 am
by zwei
Assis As wrote: ↑Mon Jul 19, 2021 8:50 am
i had followed your strategy somehow 4 revolute joint , created with two redundancies.please see file
I created 2 additional ref plane for hinge mating on the bse part and remove all the mate and replace them with hinge.
It seems fine for me